Items you need for flying and
building a Raptor 30:
Rays
Authoritative Helicopter Manual
Decent
Heli transmitter (>= FF8 discuss with your
instructor)
Raptor
30 V2 pro kit (49 bearings)
OS
32 SXH ring engine
Decent
receiver (>= 6 channels e.g. PCM 149 DP)
Futaba
4 x 3001 servo
Futaba
Gyro 401 + 9253 (or cheaper GY 240 gyro with decent servo)
Trainer
cable (to connect your instructor TX to your TX)
Blade
holder no. 3800 Thunder Tiger
Header
tank (optional)
Two
small fuel filters (between muffler and tank and between tank and carb)
Crash
kit TT3831 (optional, you will need it
though J)
VoltSpy or any other on board voltage monitor
Receiver battery, capacity >=
1500 mAh
Switch
harness Futaba (heavy duty preferred)
Ball
links (Extra set, e.g. rocket city or just Thunder Tiger)
Remote
glow adapter
Pitch meter (Vario)
Decent
Ball link pliers
Circlip pliers
Decent
Calliper
Large
metal ruler
Decent
set Hex drivers (2, 2.5, 3mm etc)
Decent
set nut drivers (4, 4.5, 5 mm etc)
Fuel line (0.5 m)
Fuel
line THIN (Graupner)
Blue
loctite
CA
(thin)
Small
Tie-raps
Spiral
flex to protect wires (5mm diameter)
Double
sided adhesive tape with (1mm thick) foam
Cleaning solvent
One
sided adhesive tape (approximately 3mm thick)
1
mm drill (Dremel)
Acid free grease (silicone grease
etc.) (should also not contain any petroleum)
2
Jezus Bolts need to be replaced (should be: 12.9 hard
steel shouldered bolts).
Startbox with:
Starter
Hex
starting extension
Start
battery
Decent
charger for your batteries
Fuel pump
Fuel
filter
Revolution
counter
Glow
plug battery
Glow
plug connector
OS
#8 glow plugs
Small
tools (screw driver etc.)